Friday 24 September 2010

Re-basing

I hit a bit of a problem with a two current Daemon Prince models. One of them is a scratch build and the other is a conversion of the Necron Nightbringer. When I put them together, I put them both on 40mm bases, as the old metal undivided Daemon Prince was on a 40mm base. Since then of course, GW have bought out the new plastic Daemon Prince, who is on a 60mm dreadnought size base (as was the old metal Nurgle DP in fact). For the tournament I'm playing in, I hadn't really thought too much about it, but I double checked with the TO and he ruled that any model must be on the same base size as the current GW model meaning a 60mm base for Daemon Princes. Probably if I'd just turned up with them on 40mm bases, I don't think anyone would have complained, but I don't want any accusations of cheese or cheating.

This gave me a problem. The two models were very solidly pinned, glued and green stuffed to the current bases and getting them off those bases would probably have damaged the models so I needed a solution. I was looking on ebay for new 60mm bases when I came across these:

These are 60mm plywood discs, and I got 24 of them for £3 or so (bearing in mind a GW base of the same size if £2.50 for one) courtesy of Fenris Games. The good part about these is that they are only 1.5mm thick.

Because the plywood bases a quite thin, I was able to mount the models on top of them without removing them from the current bases. Once they were stuck on there, I built up the rest of the base with milliput, sand, stones etc and painted them:


This saved me a whole load of hassle, money and potential damage to the models.

2 comments:

jabberjabber said...

Excellent tip Chris! I've been using table coasters from the local hardware store that are the correct size recently -- I reckon your approach is much cheaper!

Mike Howell said...

Nice idea. Thanks for the tip.